This is a Ontario M-10 Coyote Handle Grip. Has "US Army" on one side, and an eagle on the other side. It also has a small "button" on the top of the grip so you will know which side of the blade edge is down when gripping the knife. It will also fit Phrobis, Lan-Cay M9 bayonets and probably the M9 imports as well. The standard M9 blades, pommels, tangs, and hand guards will fit right onto this handle. New, but may have a few scuffs from storage/handling. USA Made.
Note: since the grip has never been installed, it is tight fitting on the blade and cannot easily be pushed on by hand. It may require light tapping with a plastic hammer to seat it onto the back of the blade. It is recommended to install the handguard, then the tang first. Fold up some old towels and place them onto a block of wood to protect the tip of the blade. Then place the knife tip onto this, slide the grip over the tang (while aligning the slots in the grip with the blade), and tap it with the rubber hammer. This should seat the grip onto the blade then the pommel and screw can be installed.